Connecting to a #Router

Stalk3r 11:49 No comments


For connecting your PC to Cisco Router or Switch using HyperTerminal, firstly you need to connect your PC to Router or Switch by using of Rollover/Rolled Ethernet cable. Now you can start Hyper-Terminal to establish a console connection and configure the device. Configure the device as I said bellow:

1:Turn on the computer. From the Windows taskbar, locate the HyperTerminal program:  Start>Programs>Accessories>Communications>HyperTerminal

2: Enter a name in the connection name field and select OK.


3:Specify the computer connecting interface. Use the drop down arrow in the Connect using: 
 field to select COM1 and select OK. (Note: It may be COM2, depending on which serial port 
 was used on the PC) 


4:Set the interface connection properties to the following: 

  • Bits per second = 9600
  • Data bits = 8
  • Parity = None
  • Stop bits = 1
  • Flow control = None


    • Then select Ok. (You may also use Restore Defaults)



                                                The connection has been successfully completed.


                               

                     Join our FB Group CCNA 200-120


    No comments :

    Post a Comment

    Subscribe to: Post Comments ( Atom )